16060 Image IMAGE: surface depth of %ld microns above maximum limit of 1000 microns Thermal The requested surface depth before a plot was above the upper limit of 1000 microns (um). The requested surface depth is specified in the error message. If a sd test series plot was started or underway, the requested surface depth for the next series step was higher than the limit. Check that the correct media type was selected for the current image, then try the image again. If the problem persists, call Creo Customer Support for help. The NVS media sd setting may be too high. The workstation specified a media type that was not normally used, which has a NVS media sd setting that is too high. A surface depth series plot was started or underway, and the requested surface depth for the for the next series step was higher than 1000 um. ../commands/plot_sd.xmlCommand: plot sd ../nvs/media_cal_sd.xmlNVS: media sd ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:31 2008 PST